Sony DTC59ES Operating Instructions Manual page 33

The end ID indicates the last position of the recording or
playback. While recording on the same tape has been done
several times, you can Jocate the point where the previous
recording terminates quickly, using the end ID.
When the end !D is detected during playback, the playback
stops and the tape is rewound to the beginning
automatically.
A 7iitiatemeleLalare mat-raeleslinie|
1 Press the "PAUSE, OREC MUTE or FADER button.
HPAUSE Record-pause mode
OREC MUTE Record-pause mode after a
sound muted portion is
created for 4 seconds.
FADER Record-pause mode after
the sound fades out.
2 Press the END ID WRITE button.
The END ID WRITE indicator lights.
— START ID ]
r— SKIP ID
END ID
Fvrire-
3 Press the IIPAUSE or > (play) button to release the
record-pause mode.
The "EE" indicator appears on the display.
The end ID is written for about 9 seconds (18 seconds
in the long-play mode). Tape returns to the beginning
of the end ID after the end ID is written.
oe
Ee:
aX
" N
After you write an end ID
The portion after the end ID position cannot be played
back. (The "EE" indicator appears at the PGM NO. display.)
Erase the end ID (page 34) where you want to play back
the portion after the end ID position.
Writing during Playback (Rehearsal function)
* During playback, no end ID can be written on a blank
section.
© To write the end ID just before a blank section with the
end search function, perform "Writing during Recording"
described on the left colums.
© Make sure that the safety tab of the cassette is closed.
1 During playback, press END ID WRITE at the
desired position.
The REHEARSAL indicator lights and the WRITE
indicator flashes, and the portion for 3 seconds to the
point where you pressed the END ID WRITE button, is
played back repeatedly (rehearsal function).
The end of the repeated portion will be the beginning
of the end !D.
2 Press the << or >> button to adjust the "repeat
end" point.
The "repeat end point is shifted backward with the <<
button or forward with the » button by 0.3 of a
second.
The indicator at the MARGIN display shows how much
the "repeat end" point is shifted from the point where
you pressed the END ID WRITE button.
(— START 7]
— sKIPID
Thevennsi—
LEB x ENDID
; f walre—
7
When you pressed » twice
3 After setting the beginning of the end ID at the
desired point, press the END ID WRITE button
again.
The "EE" and WRITE indicators light, and an end ID is
written.
Note on the point where an end ID is written
During rehearsal function, an end ID is written at the end of
the repeated portion as illustrated.
Point where you pressed
Repeated portion END ID WRITE
Selection Selection
End ID (9 seconds)
Each time you press >> —
3 seconds
0.3
Each time you sec.
press << 1+ —|
Normally, the repeated portion is played back 5 times.
When the << or »® button is pressed while the repeated
portion is played back, the repeated portion is played back
up to 8 times max, and then tape stops.
33