LG WD-3274RHD Owner's Manual page 15

• Press TEMP, to cycle through _
the temperature choices, w,_v_
• Select a water temperature w_oLo
based on the type of load you _
are washing. Use the warmest Tec_._u_
water safe for fabrics, Follow
garment label instructions. TEMe
• Warm dnses leave the loads
dryer than cold rinses, Warm
rinses increase wrinkling, In cold
climates, a warm rinse makes the load mere
comfortable to handle. Cold rinses save energy.
• Warm rinses are regulated at approximately 75 _F
(24 _C), This is a cooler warm rinse than you are
used to, but it saves energy and gives proper
rinsing, The load is a comfortable temperature
remove from the washer,
• Water temperature can be selected as below
according to the program,
- SANITARY
HOT/COLD
- COTTON
WARM/COLD "i) WARM/WARM-)HOT/COLD -.)
TAP COLD/COLD-.) COLD/COLD
- PERM. PRESS
WARM/COLD-)WARM/WAR-)TAP COLD/COLD-)COLD/COLD
- WOOL/SILK & RINSE+SPIN
COLD/COLD -') WARM/COLD --)
WARM/WARM-)TAP COLD/COLD
Selected temperature's lamp turns on,
For the more detailed information,ple_e refer to thepage12.
TemperatureGuide
Wash Water Temperature Suggested Fabdc_
Hot Whitesanti pasteis
111_F (_ C) or above Heavy anti greasy solts
Warm Bright colors
90_-110 _F (3Z- 43_C) Moderateto light solIs
Cold Colo_ that bleed or fade
70_-90 _F (21_-3Z C) Light soils
Inwash water temperatures colder than 70" F (21' C),
detergents do not dissolve weU,Soils may be difficultto
remove.
SPIN
• By pressing the SPIN button,
the spin rpm can be chosen,
-RINSE HOLD
- NO SPIN
- 400
- 800
-1000
-1400
• Spin rpm is available according to the program as
foltuws.
[Wash Programs]
- SANITARY & COTTON & RINSE+SPIN
800--)1000-.)1400-.)Rinse HOld-.)NoSpin.-.)400
- PERM. PRESS
800,--)1000-.)Rinse Holri-YNo Spin,--)400
- WOOL/SILK
400,--)800.-.)1000.-.)Rinse Hold.-.)No Spin
[Wash/Dry Programs]
- SANITARY & COTTON & RINSE+SPIN
1400-.)800-.)1000
- PERM. PRESS
1000-) 800
• If NO SPIN is selected, the washer stops
after draining water,
The required lamp will light up for
identification.
• [s selected by pressing the SPIN button
repeatedly this function leaves clothes in the
washer; suspended in the water after a rinse
without entedng into spin,
• To proceed through to a drain or spin,
once the rinse hold function is completed
using to program dial scroll to the required
program, (Spin or Pump)
The required lamp will light up for identOTcadon.