Electrolux EB6GL70KCN User Manual page 26

12.8 Tank Emptying
Use it after cooking with steam heating
function to remove the residual water from
the water drawer.
1. Turn off the appliance and wait until it is
cold.
2. Remove all accessories.
3. Place the deep pan on the first shelf
position.
4. Select: Menu / Cleaning / Tank Emptying.
Duration: 6 min
5. Turn on the function and follow the
instruction on the display.
6. When the function ends, remove the deep
pan.
When this function works, the lamp is off.
12.9 Removing and installing the
door
You can remove the door and the internal
glass panels to clean it. The number of glass
panels is different for different models.
WARNING!
The door is heavy.
CAUTION!
Carefully handle the glass, especially
around the edges of the front panel. The
glass can break.
1. Fully open the door.
2. Press the clamping levers
door hinges.
A
3. Close the oven door to the first opening
position (at approximate angle: 70°).
4. Hold the door with one hand on each side
and pull it away from the oven at an
upwards angle.
26 ENGLISH
5. Put the door with the outer side down on
6. Hold the door trim
7. Pull the door trim to the front to remove it.
8. Hold the door glass panels on their top
9. Clean the glass panel with water and
After cleaning, do the above steps in the
opposite sequence. Install the smaller panel
first, then the larger and the door.
Make sure that the glass panels are inserted
in the correct position otherwise the surface
on the two
of the door may overheat.
12.10 Replacing the lamp
Risk of electric shock.
The lamp can be hot.
A
1. Turn off the appliance and wait until it is
2. Disconnect the appliance from the mains.
3. Place the cloth on the oven floor.
Top lamp
1. Turn the glass cover to remove it.
a soft cloth on a stable surface.
the door at the two sides and push
inwards to release the clip seal.
2
B
edge one by one and pull them up out of
the guide.
soap. Dry the glass panel carefully. Do
not clean the glass panels in the
dishwasher.
WARNING!
cold.
on the top edge of
1