Sony VCRplus+ SLV-775HF Operating Instructions Manual page 69

Operation
(when recording on this VCR)
Before you start editing
• Turn on your TV and set it to the
video channel.
• Press INPUT SELECT on the remote
commander to display "LI" or "L2" in
the display window.
• Press TAPE SPEED on the remote
commander to select the tape speed,
SP or EP.
1
Insert a source tape with its safety tab removed into the other
(playback) VCR. Search for the point to start playback and set it to
playback pause.
2
Insert a tape with its safety tab in place into this (recording) VCR.
Search for the point to start recording and press
II
PAUSE.
3
Press
#
REC on this VCR and set it to recording pause.
4
To start editing, press the
II
PAUSE buttons on both VCRs at the same
time.
To stop editing
Press the ■ STOP buttons on both VCRs.
Note
• If you start recording following the procedure above, the VCR won't start recording
with theAPC function. To record a tape with the APC function, press • REC again
during recording pause in step 3 so that the VCR analyzes the tape. Then when you
start recording in step 4, press II PAUSE immediately after the APC indicator stops
flashing. If you press II PAUSE before the APC indicator stops flashing, the APC
function is canceled.
II PAUSE
m
■
m
• REC
Additional Operations
69