Table of Contents
Advertisement
9
Torn the SEL/PUSH
EXEC
dial to
select
[LLINK]
or |IR], then press the
dial.
When connecting
with an i.LINK
cable
After selecting
[i.LINK], go on m "Slep 2:
Adjusting
_he synchronization
of the VCR"
(p. 70).
When connecting
with an A/V
connecting
cable
After selecting
[IR], follow _he procedure
described
in "To set the [IR SETUP] code"
(p. 70).
To set the [IR SETUP]code
When you connect with an A/V connecting
cable, you need to check the [IR SETUP] code
signal to see if your VCR can be operaled by
your camcorder
(infrared ray emitter).
Remote sensor
VCR
Infrared ray
emitter
1
Turn
the SEL/PUSH
EXEC dialto select
[IR SETUP],
then press the dial.
2
Turn the SEL/PUSH
EXEC dial to select
the [IR SETUP] code of your VCR, then
press the dial.
For |he [IR SETUP] code of your VCR,
rel_r m "[IR SETUP] code list" (p. 65).
When _here is more than one code listed for
_he manufacturer
of your VCR, try each
code and find the most appropriate
one.
3
Turn
the SEL/PUStt
EXEC dial to select
[PAUSEMODE],
then press the dial.
4
Turn the SEL/PUSH
EXEC dial to select
the mode to cancel recording
pause on
the VCR, then press the dial.
Refer to the operating
instructions
supplied
with your VCR for details on operation.
5
Point the infrared
ray emitter of your
eamcorder
towards the remote sensor on
your VCR, from about 30 cm (12 in.)
away, with no obstructions.
6
Insert a cassette into your VCR, and set
the VCR to recording
pause.
7
Turn the SEL/PUSH
EXEC dial to select
[IR TEST], then press the dial.
8
Turn the SEL/PUSH
EXEC dial to select
[EXECUTE],
then press the dial.
The recording
starts oll your VCR when 1he
setting is correct. [COMPLETE]
appears
when lhe [IR SETUP] code test is finished.
Go on to "Step 2: Adjusting
_he
synchronization
of the VCR" (p. 70).
When recording fails to start, select anolher
IR code and try again.
Follow
the steps below when you are
performing
digital program
editing
for the
first time to a tape in a VCR. You can skip
this setting
if you have set up your VCR
before using the following
procedure.
You can adjust the synchronization
of your
camcorder
and the VCR to avoid not
recording
the starting
scene.
Remove
the cassette
from your
camcorder.
Prepare
a pen and paper
to take notes.
Set the VCR to recording
pause
mode.
Skip this step if you have selected
[i.LINK]
in step 9 on p. 70.
O Note
• Run 1he tape for about 10 seconds before
pausing.
The starting scenes may not get
recorded
when you start recording
from
the beginning
of|he tape.
70
Dubbing/Editing
Advertisement
Table of Contents
