Using The Auto Aspect Feature - Toshiba 51HC85 Owner's Manual

Using the AUTO ASPECT feature
When the AUTO ASPECT feature is set to ON and the monitor
receives a 480i signal (other than an HDMI input source), the picture
size is automatically selected (as described in the following table).
4:3 Normal Natural
16:9 Full Full
4:3 Letter box TheaterWide 2
Not defined (no ID-1 data) User-set mode
If the signal does not include aspect information, the picture size you
selected on pages 27-28 is displayed.
To turn on the AUTO ASPECT feature:
1. Press MENU, and then press • or • until the PICTURE menu
appears.
P I CTURE
MODE
P I GTURE SETT I NGS
D I SPLAY FORMAT .................. _ O_i
(;ONVLHGLNCL
_t_: SELECT iEXiiiiii;_i: END
Note:
The AUTO ASPECTfeatuf_ is available for
additional formats when viewing HDMI
sources because AUTO ASPECToperates
based on information found in the digital
HDMI signal (not ID- 1 data).
MENU
AV< _,
ENTER
2. PressAorVtohighlightAUTO ASPECT, andthenpress
ENTER.
@: SELECT _}NTER : S ET
3. Press • or • to select ON, and then press ENTER.
NOTICE OF POSSIBLE ADVERSE
EFFECTS ON MONITOR PICTURE
DISPLAY
Avoid displaying stationary images on
your monitor screen for extended periods
of time. Fixed(non-moving) patterns or
images 0ncluding but not limited to PIP/
POPwindows, closed captions, video
game patterns, TVstation Iogos (from
VCR, etc.), stock tickers, websites, and
special formats that do not usethe entire
screen) can become permanently
ingrained in the cathode ray tube(s) of
the monitor and cause subtle but
permanent ghost images.This type of
damage is NOT COVERED BY YOUR
WARRANTY. See item 33 on page 4 for
details.
3O
e01E 27-3:51HC85 30
Black
(E) 51 HC85, 57HC85, 65HC85
05.4.28, 6:16 PM