Table of Contents
Advertisement
Safety Guidelines
WARNING: This device must be operated with the original power supply, part number FSP273-4F01.
CAUTION:
The power supply outlet should be located near the 1080p monitor and should
be easily
accessible. Always use the appropriate AC cord that is certified for your specific country. Some examples
are listed below:
USA .................. UL
Switzerland .....
SEV
Canada ............. CSA
Britain .............
BASE/BS
Germany .......... VDE
Japan ............... Electric Appliance Control Act
IMPORTANT
NOTICE
CONCERNING
POWER
CORD
SELECTION
The specific power cord for this 1080p monitor is enclosed and has been selected according to the country
of destination and must be used to prevent electric shock. Use the following guidelines if it is necessary to
replace the original cord set, or if the cord set is not enclosed. The female receptacle of the cord set must
meet IEC-60320 requirements and should look like Figure A1 below:
Figure
AI
Figure
A2 @_
For the United
States
and Canada
In the United States and Canada the male plug is a NEMA5-15 style (Figure A2), UL Listed, and CSA
Labeled. For 1080p monitors that are placed on a desk or table, only SJT type cord sets may be used. For
1080p monitors placed directly on the floor, type SVT or SJT cord sets may be used. The cord set must be
selected according to the current rating for the monitor. Please consult the table below for the selection
criteria for power cords used in the United States and Canada.
Cord
Type
Size
of Conductors
in Cord
Maximum
Current
Rating
of Unit
SJT
18 AWG
10 Amps
16 AWG
12 Amps
14 AWG
12 Amps
SVT
18 AWG
10 Amps
17 AWG
12 Amps
FCC Compliance
Statement
This equipment has been tested and complies with the limits for a Class B digital device, pursuant to part 15
of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in
a residential installation. This equipment generates, uses, and can radiate radio frequency energy, and may
cause harmful interference
to radio communications
if not installed and used in accordance
with the
instructions. However, there is no guarantee that interference will not occur in a particular installation. If this
equipment does cause harmful interference to radio or video reception, which can be determined by turning
the equipment off and on, the user is encouraged
to try to correct the interference
by one or more of the
following measures:
•
Reorient or relocate the receiving antenna.
•
Increase the separation between the 1080p monitor and receiver.
•
Connect the equipment into an outlet on a circuit different from that to which the receiver is
connected.
•
Consult the Westinghouse Service Center or an experienced technician for assistance.
FCC Warninq
To assure continued FCC compliance, the user must use a grounded power supply cord and the
provided shielded video interface cable with bonded ferrite cores. If a BNC cable used, use only a
shielded BNC (5) cable. Also, any unauthorized
changes or modifications
not expressly approved by
Westinghouse
Digital will void the user's authority to operate this device.
Advertisement
Table of Contents
