Table of Contents
Advertisement
REMOVING CONTENTS FROM PACKAGING
Check shipping carton and machine for damage before unpacking. Carefully remove packaging materials, parts
and machine from shipping carton. ALWAYS check for and remove protective shipping materials around motor and moving parts.
Lay out all parts on a clean work surface.
•
Compare package contents to Packaged Contents List prior to assembly to make sure all items are present. Carefully inspect
parts to make sure no damage occurred during shipping. If any parts are missing, damaged or pre-assembled, DO NOT
assemble. Instead, call DELTA
If any parts are missing, DO NOT attempt to plug in the power cord and turn the power on. The saw should ONLY be
•
energized after all parts have been located and correctly assembled.
•
This saw is packaged and shipped with saw head secured in the down position. Please see "PREPARATIONS FOR
TRANSPORTATION" section of this manual for instructions on how to use the saw head lock pin. Once the saw head is in the
upright position, remove Styrofoam packaging block and discard. Cut and remove the plastic tie-wrap securing the saw-head
from moving.
•
Remove the plastic tie-wrap securing the sliding mechanism.
PC1
PACKAGE CONTENTS DESCRIPTION
DELTA
26-2310 miter saw
®
PC1
T30 Torx/Blade Wrench
PC2
(on machine) *see Figure 1 for storage location
Work Clamp
PC3
Dust Bag
PC4
UNPACKING
Customer Service at (toll free) 1-800-223-7278.
®
PC2
PC3
Figure 3
11
PC4
PC5
Support Extension (2)
PC5
Extension Clamp (2)
PC6
Split Lock Washer (2)
PC7
Wing Nut (2)
PC8
2 1/2 inch Dust Port Adapter
PC9
PC6
PC7
PC8
PC9
Advertisement
Table of Contents
