Table of Contents
Advertisement
5. To mount anti-tip bracket to wood floor, drill two
holes at the positions marked on the bracket template.
Remove template from floor.
To mount anti-tip bracket to concrete or ceramic floor, use a
" (4.8 mm) masonry drill bit to drill 2 holes at the positions
marked on the bracket template. Remove template from floor.
6. Tap plastic anchors into holes with a hammer.
7. Align anti-tip bracket holes with holes in floor. Fasten anti-tip
bracket with screws provided.
Depending on the thickness of your flooring, longer screws
may be necessary to anchor the bracket to the subfloor.
Longer screws are available from your local hardware store.
8. Move range close to opening. Remove shipping base,
cardboard or hardboard from under range.
9. Move range into its final location, making sure rear leveling leg
slides into anti-tip bracket.
10. If installing the range in a mobile home, you must secure the
range to the floor. Any method of securing the range is
adequate as long as it conforms to the standards in the
"Location Requirements" section.
11. Continue installing your range using the following installation
instructions.
" (3.2 mm)
Verify Anti-Tip Bracket Location
Use two or more people to move and install range.
Failure to do so can result in back or other injury.
1. Pull drawer open to first stop position. Lift front of drawer to
clear white wheels in drawer guides. Remove drawer and set it
aside on a protected surface. See the Use and Care Guide for
the model drawer removal.
2. Making sure the anti-tip bracket is installed:
Look for the anti-tip bracket securely attached to floor.
Slide range back so rear range foot is under anti-tip
bracket.
3. If installing the range in a mobile home, you must secure the
range to the floor. Any method of securing the range is
adequate as long as it conforms to the standards in the
"Location Requirements" section.
Place rack in oven. Place level on rack and check for levelness,
first side to side; then front to back.
If range is not level, pull range forward until rear leveling leg is
removed from the anti-tip bracket. Use
channel lock pliers to adjust leveling legs up or down until range is
level. Push range back into position. Check that rear leveling leg is
engaged in anti-tip bracket.
NOTE: Oven must be level for satisfactory baking performance.
Typical rigid pipe connection
A combination of pipe fittings must be used to connect the range
to the existing gas line. Your connections may be different,
according to the supply line type, size and location.
1. Apply pipe-joint compound made for use with LP gas to all
pipe thread connections.
WARNING
Excessive Weight Hazard
Level Range
" drive ratchet and
Make Gas Connection
7
Hide quick links:
Advertisement
Table of Contents
