AEG FFE73600PM User Manual page 24

24 www.aeg.com
820-880 mm
600 mm
14.1 Adhesive steam
protection
Clean the bottom part of the kitchen
worktop and apply the adhesive plastic
film along the entire width.
14.2 Adjusting the height of
the appliance
1. Remove the adjustable plinth.
2. To adjust the front height, turn the 2
front feet counterclockwise to raise
the appliance.
818-878 mm
597 mm
600 mm
E
3. To adjust the rear height, turn the
middle screw counterclockwise to
raise the appliance.
14.3 Adjusting the level of the
appliance
Correct levelling of the appliance allows
the door to close and seal properly.
If the door does not close correctly, raise
or lower the adjustable feet to level the
appliance.
After adjusting the level of the appliance,
assemble the adjustable plinth on the
appliance.
Once the installation is completed, make
sure that the bottom of the adjustable
plinth is aligned with the floor.
14.4 Installing the appliance
under a kitchen counter or to
adjacent units
The appliance has 6 fixing points:
• 2 external fixing points (2 brackets +
screws)
• 4 internal fixing points (4 spacers +
screws)
Use the 2 external fixing points when
installing the appliance under a kitchen
counter or to adjacent units or if the
opening for the appliance is greater than
600 mm.