Table of Contents
Advertisement
EN
Introduction
Please take a few moments to carefully read
through this manual. Correct maintenance and
operation of this machine will provide the best
possible performance from your POLAR product.
Pack Contents
The following is included:
•
POLAR Refrigerator
•
Shelf guide (2 per door)
•
Shelf (1 per door)
•
Glass sneeze guard set
•
Instruction manual
POLAR prides itself on quality and service, ensuring
that at the time of unpacking the contents are
supplied fully functional and free of damage.
Should you find any damage as a result of transit,
please contact your POLAR dealer immediately.
Installation
Note: Not for use in vans or trailers, food
trucks or similar vehicles.
Note: If the unit has not been stored or
moved in an upright position, let it stand
upright for approximately 12 hours before
operation. If in doubt allow to stand.
1. Remove the appliance from the packaging.
Make sure that all protective plastic film and
coatings are thoroughly removed from all
surfaces.
2. To optimize performance and longevity, ensure
a minimum clearance of 2.5cm is maintained
between the unit and walls and other objects,
with a minimum 20cm clearance on the top.
NEVER LOCATE NEXT TO A HEAT SOURCE.
Note: Before using the appliance for the
first time, clean the shelves and interior
with soapy water.
3. Set the brakes on the castors to keep the
appliance in position.
Fitting the Shelves
1. Place one set of shelf guides on either side of
the cabinet at the desired height.
2. Slide the shelf into place.
3. Repeat for the remaining shelves.
4
UA017-A to UA019-A_CT393-A to CT395-A_A5_v1_20230726.indb 4
UA017-A to UA019-A_CT393-A to CT395-A_A5_v1_20230726.indb 4
Fit straight glass sneeze guard
(FT367/FT368/FT369) onto counter
unit (FT281-A/FT283-A/FT285-A)
1. Screw the collars to the rim of the appliance.
Note: Ensure the hole in the collar for the
grub screw faces inwards.
2. Slot the two side panels into the collars, with
the holes in the glass at the top.
Note: Ensure the screw hole furthest from
the edge of the panel goes to the back of
the appliance.
3. Screw a grub screw into each collar to secure
the panels.
Note: Ensure the soft end of the grub screw
is the end making contact with the glass.
Do not over-tighten the grub screws as it
will result in the glass breaking.
4. Slot the rear panel into the collars, with the
holes in the glass at the top.
5. Screw a grub screw into each collar to secure
the panel.
6. Slot the plastic plugs into each of the holes.
7. Screw the brackets to the inside of each pane
using the bolt assemblies.
Note: Ensure the short end of the bolt
assembly is on the outside of the panels.
8. Place the top panel onto the brackets, ensuring
all holes line up.
9. Insert the plugs and attach the top panel to
the brackets with the bolt assembly.
Bracket
Glass Panel
Bolt Assembly
Plug
Bolt Assembly
2023/7/26 17:27
2023/7/26 17:27
Advertisement
Table of Contents
