Placing The Camera On The Cyber-Shot Station; Removing The Camera From The Cyber-Shot Station; Charging The Battery Pack - Sony Cyber-shot CSS-HD2 Operating Instructions Manual

• The Remote Commander range is less than
five meters (for indoor use). Point the Remote
Commander at the remote sensor of the Cyber-
shot Station. Try adjusting the angle of the
Remote Commander if you cannot operate the
Cyber-shot Station.
Placing the camera on the
Cyber-shot Station
Remove the Adaptor ring, the Conversion lens,
etc. from the camera.
Attach the camera as shown below.
• Be sure to turn off the camera before placing it on
the Cyber-shot Station.
• When attaching the camera, make sure to insert
the camera straight down.
'~'Tips
• Make sure that the camera is securely attached to
the Cyber-shot Station.
14-GB
Removing the camera from
the Cyber-shot Station
• Hold the Cyber-shot Station down when you
remove the camera from the Cyber-shot Station.
"Notes
• When removing the camera, make sure to lift the
camera straight up. It may damage the camera or
the Cyber-shot Station when some extra force is
added to the front or the sides.
Charging the battery pack
Place the camera with the battery pack
inserted on the Cyber-shot Station.
Charging starts automatically. The CHARGE lamp
of the Cyber-shot Station lights up.
• When the camera is turned on, the Cyber-shot
Station cannot charge the battery pack.
• When the charging reaches to Normal charge*,
the CHARGE lamp goes off.
*
Recording and playback time with Normal
charge is approximately 90% of Full charge.
• For the time of the full charge for a completely
discharged battery at the temperature of 25 °C
(77 OF), see the table below.
DSC -T300fT75fT70fT2 Approx.
160 minutes
DSC-
Approx.
W3001W1701W15011W1301
W1251W1201W1151W110
230 minutes
- It may take longer to charge, depending on the
charging condition and environment.