Starting - Atlas Copco XATS 138 PE Stage V APP Instruction Manual

STARTING

Open the hood and switch on the main switch (1).
Close the hood.
Switch the controller on by pressing the Power
button.
The instrument panel will now perform a selftest; the
following display will be shown and the controller is
initialized:
Xc2003
v1.00.0
During initializing all buttons/inputs/outputs/alarms
are inactive.
This view will be shown for about 2 seconds, after
which the display will show the Main View.
MAIN VIEW
VESSEL BLOWING OFF
3.9
40% 1286h 1200RPM
The actual vessel pressure is shown. If the measured
vessel pressure is higher than 1.5 bar, the unit will not
start. The vessel pressure has to be lowered by
opening the blow down valve. After power up, the
vessel pressure normally is low enough to proceed
with the starting procedure.
If the Power button is switched to switch
off while the vessel is blowing down, it
will not power down for as long as the
vessel pressure is higher than 1.5 bar.
Active Buttons
- 38 -
The display will change to
MAIN VIEW
POWERING UP e-XTENSION
40%
followed by
MAIN VIEW
3.9bar
READY TO START
40%
The machine is now ready to be started and is waiting
for a start command.
0.0
1286h --RPM 0.0bar
0.0
1286h --RPM 0.0bar
Active Buttons