Table of Contents
Advertisement
Operating instructions
PARKING, TOWING AND LIFTING
INSTRUCTIONS
Safety precautions
The operator is expected to apply all
relevant Safety precautions.
Attention
After the first 100 km travel:
Check and retighten the wheel nuts
and towbar bolts to the specified
torque.
See
section
specifications.
When using a towing vehicle
manoeuver the unit, take care that the
support leg is lifted maximally.
When the jockey wheel is on the ground,
the unit may only be manoeuvered by
hand.
PARKING INSTRUCTIONS
Technical
to
When parking a compressor, secure support leg or
jockey wheel (1) to support the compressor in a level
position. Be sure that the jockey wheel (1) is blocked
by the blocking pin (3).
Apply parking brake by pulling parking brake handle
(2) upwards, towards towing eye. Place the
compressor as level as possible; however, it can be
operated temporarily in an out of level position not
exceeding 15°. If the compressor is parked on sloping
ground, immobilize the compressor by placing wheel
chocks in front of or behind the wheels.
- 23 -
Locate the rear-end of the compressor upwind, away
from contaminated wind-streams and walls. Avoid
recirculation of exhaust gas and warmed-up cooling
air. This causes overheating and engine power
decrease. Do not obstruct air evacuation from the
cooling system. The compressor oil lifetime will be
shortened when the compressor inlet air is
contaminated.
Advertisement
Table of Contents
