Omega FPD-4000 Series User Manual page 23

Turn On Linearizer: Press the slider to turn the linearizer On and Off. The Slider
will turn pink to indicate it is On. Press the Set button for selection to take place.
Changing Values: To change values in the table, press on the desired data point
that needs changing. Enter in new values and press the Set button to save the
changes.
Entering New Values: To enter in values to the linearizer, press the (+) button.
This will bring up the option to type in a desired frequency and corresponding
K-factor. After values are entered, press Add, this should input the values into
the table. Continue to the next Row and repeat the process for each additional
value needed. There are 10 rows available, but it is not required to fill them all.
When desired amount of points are entered, press SET to save the changes.
Deleting Values: To Remove a value, press the slider next to the row that needs
to be delete. The slider will turn Pink to indicate the row is selected. When all
desired rows are selected, press the ( - ) button to remove them. Press Set to
save the changes.
23