4-6-5.
Priority Alert
Memory
channel
1 will be checked
at approximately
5 se-
cond intervals to check for activity when this function is
selected.
1. Enter the frequency that you wish to monitor in memory
channel 1 of the MAIN BAND (See Memory Entry page
23).
. Adjust the SOL control to the threshold point.
. Wit the TM-721A;
Press the F key and then SHIFT/AL
key.
With the TM-721E;
Press the AL key.
"AL" indicator will appear on the LCD display.
If the channel is busy, a beep will sound.
Note:
1. If the audio confirmation function has been turned
OFF, no beep will sound, even if Memory Channel 1
is busy.
2. During the period channel 1 is being monitored, only
the beep will sound.
. With the TM-721A; Press the F key and then SHIFT/AL
key again.
With the TM-721E;
Press the AL key again.
"AL"
will disappear, disabling the Priority Alert. func-
tion.
4-6-6.
Memory Channei Lockout
The Memory Channel Lockout function allows you to tem-
porarily skip unwanted
Memory
Channels
during Memory
Channel Scan.
1.
Press the MR/M
key to select the Memory
Channel
mode.
2. Select the Memory Channel that you wish to skip by us-
ing
the
MAIN
Tuning
control
or
the
microphone
UP/DWN switches.
. Press the F key and then
MUTE,
th
ce
Sr.
HET
YOR
OR
e
SCAN/L.OUT
key.
py
Coo
6g oo
Whenever
the
F key
is
A
A
pressed,
the
F indicator
will turn ON.
Note:
You must complete the desired action within 5 seconds,
or the F indicator will turn OFF. If the indicator goes off,
you must press the F key again.
A star (*) will appear to
the
left of the
Memory
Channel number. This in-
172.
dicates the Memory Chan-
f| SeRF
nel will be skipped during
Memory
Channel
Scan
operations.
. Repeat steps 2 and 3 to lock out any other Memory
Channels that you want to skip.
. To cancel the lockout, select the desired Memory Chan-
ne! as discribed in steps 1, 2, and 3 above.
The star (%) will go out. The Memory Channel! will now
be scanned normally.
5. BLOCK DIAGRAM and
SCHEMATIC DIAGRAM
Another sheet
27