Using The V.reader Touch Screen; Cleaning The V.reader Touch Screen; Inserting An Sd Card - VTech V.Reader User Manual

Hide thumbs Also See for V.Reader:

Table of Contents

using the V.reader

V.reader

has a touch-sensitive screen that you can interact with by either using

your finger or the included pen. Lightly touch the screen with your finger or the

pen. In Watch the Story mode, flick the screen to turn the page forward or back.

note:

• Use only enough pressure to operate the game. Too much pressure may

damage the touch screen.

• Do not use the pen if it is broken.

• Do not use any other pens on the touch screen other than the V.reader

• Put the pen back in the pen holder when not in use.

cleaning the V.reader

If the screen on your V.reader

on it, you can clean it with a soft, lint-free cloth.

1. Slightly dampen the cloth with a little water and wipe the screen to loosen dirt.

2. Using a clean and dry cloth, wipe the screen dry. Repeat these two steps as

needed.

You can insert an SD card (not included) into your V.reader

content.

• Make sure the unit is turned off.

• Locate the SD card slot on the back of V.reader

• Open the SD card cover with a screwdriver, coin, or other household tool.

• Insert the SD card, as shown in image 4 & 5 (on the next page).

• Make sure to replace the SD card cover.

Get other manuals https://www.bkmanuals.com

touch screen

has visible smudges, fingerprints, or other material

, to store downloaded

pen.

Table of Contents