Makita WT001G Instruction Manual page 10

5. When the specified torque is attained, the bolt
tip will be sheared at its notched portion. The bolt tip
remains inside the inner sleeve.
Fig.13
► 1 . Notched portion 2. Bolt tip
6. Release the switch trigger and withdraw the tool in
a straight line.
Fig.14
► 1 . Outer sleeve
7. Pull the eject lever to eject the bolt tip from the
tool. Catch the sheared bolt tips to prevent them from
falling.
Fig.15
► 1 . Bolt tip
1
2
1
1
NOTICE:
Washer and nut have head and tail.
Head has identification mark for nut and chamfer
for washer. When placing them, be careful not to
place in reverse.
1
Fig.16
► 1 . Identification mark 2. Nut 3. Bolt 4. Chamfered
5. Washer
NOTICE:
Replace nut, bolt and washer all
together at one time when these rotate together,
nut rotates excessively or a bolt protrude from
nut surface too much or less.
NOTICE:
Do not reuse used nut, bolt and washer.
The range for the remaining length of bolts after cutting
off the bolt tips are determined by bolt size. Refer to the
table below and choose shear bolts according to the
thickness of workpiece to be fastened.
Bolt size
M16
M20
M22
1
Fig.17
► 1 . Remaining length
NOTICE:
Use bolts with the remaining length
within the range shown in the table above as bolts
with different size have different maximum and
minimum remaining length.
NOTICE:
Be careful not to use bolts beyond
the specified range which may cause the tool
malfunction.
10 ENGLISH
2
Maximum remain- Minimum remain-
ing length ing length
20 mm 4.5 mm
15 mm 5.5 mm
14 mm 7 mm
3
4
5