Table of Contents
Advertisement
(9) Remove the two screws H and the one screw J attaching
the frame (upper).
(10) Remove the four tabs, then remove the frame (upper).
(11) Remove the one screw K attaching the OPE1 board as-
sembly, then remove the OPE1 board assembly.
Tab
H
K
OPE1
Board
assembly
3.6
Removing the monitor assembly (See Figure 26, Figure
27)
• Removing the monitor assembly from the upper assembly.
(1) Remove the two screws A and the two screws B attaching
the monitor cover assembly, then remove the monitor cov-
er assembly.
Screw A: Narrow
(2) Pull out the wires from the connectors CN701, and
on the MONI board, then remove the hinge unit assembly.
Hinge unit
assembly
CN703
Frame (upper)
Tabs
Fig.25
Screw B: Thick
Monitor cover assembly
A
CN701
Fig.26
(3) Removing the four screws C attaching the bracket (LCD)
enables to release each part.
• When assembling the parts, be careful with the assem-
bling order and direction of each part.
• Do not push the LCD surface as it may be damaged.
• Be careful in handling the surface of the LCD and the
monitor, and do not damage, soil, or leave fingerprints. If
the surfaces are soiled, gently wipe them off with soft
cloth.
J
LCD Bracket
Spacer (LCD)
LCD Module
Support plate
side
LCD Case
CN703
B
3.7
Removing the view finder assembly (See Figure 28,
Figure 29, Figure 30, Figure 31, Figure 32, Figure 33)
• Remove the view finder assembly from the main unit.
(1) Remove the eye cap.
• When attaching the eye cap, align the positions as
shown in the figure.
MONI Board
Sheet (M.REF)
Light guide
Sheet (M.DIFF)
Sheet BEF
Turn
Put it on slit
of MONI case.
MONI Case assembly
Fig.27
Match and attach this position.
Fig.28
(No.HC044<Rev.001>)1-9
C
Eye cap
Advertisement
Table of Contents
