Installation Procedure - Mitsubishi Electric 800 Series Instruction Manual

2.2

Installation procedure

1.
Remove the inverter front cover. (Refer to Chapter 2 of the Instruction Manual (Detailed) of the inverter instructions for
removing the front cover.)
2.
Insert two spacers into the mounting holes that will not be used for mounting screws (see the diagrams on
identify the holes).
3.
Fit the board mounted option connector on this product to the guide of the option connector on the inverter, and insert the
option as far as it goes. (Insert it to the inverter option connector 1 or 2.)
4.
Fasten this product to the inverter using the two mounting screws through the holes on either side (tightening torque 0.33
N·m to 0.40 N·m). If the screw holes do not line up, the connector may not be inserted deep enough. Check the
connector.
Spacer
Example of installation to connector 1
Spacer
INSTALLATION AND WIRING
page 12 to
2
11