Panasonic Quasar Omnivision VHQ040M Operating Instructions Manual page 13

"Important: If the remote contro! POWER, ACTION, PROG, CH4/¥, NUMBERED keys,
INPUT, SEARCH or ADD/DLT button does not work when pressed, press
the VCR button on the remote and try the button again.
Review, Replace or Clear Program Contents:
(Recording is not in progress)
1 Repeat steps 1~3 on page 12.
2
Select program.
1) Press AY to
select number.
P DY STAAT STOP CH SPD
1 DAY 9:00412:004 08 SP
CANCEL : ADD/DLT KEY
SELECT 1-8:4 ¥ KEY
ENTER :» KEY
END :PROG/ACTION KEY
OM E START STOP CH
8 SAT 10:00P 12:00P 125 2) Press AV «> to
DBAY\ SP set new program
SEA LD contents.
SELECT START DATE
SELECT: 4 ¥ KEY
SET ¿d > KEY
END ¡PROG/ACTION KEY
or
To Clear program...
P DT START STOP
2 B 10:00P 12:00P
3 10 8:00P 9:00P
4 SU 9:00P 10:00P
1) Press ADD/DLT to
clear.
ADD/DLT
SELECT 1-8:a v KEY
ENTER :» KEY
END :PROG/ACTION KEY
End the program.
1) Press PROG (or ACTION).
* If there are programs, press
POWER off.
4 of
important notes when using a DSS receiver
+ When recording programs via a DSS receiver, the DSS
receiver must be left on.
» When recording programs via an antenna or cable, the DSS
receiver must be turned off.
1) Press > to display.
To cancel Timer Recording
(Recording is in progress)
Press POWER and then STOP
within 10 seconds to cancel the
Timer recording. (The TIMER
indicator goes out in the Multi
Function Display.)
Multi Function Display
SELECT/
SET
A :PLAY
STOP
d :REW
> :FF
Suip.1 Jau
4 proc
4 ACTION
3 ADD/
DELETE
13