Sony HT-DDW750 Operating Instructions Manual page 28

Before receiving broadcasts, make sure you
have connected FM _md AM _mtennas to the
receiver (page 7).
Notes
• Do not press any button on the receiver or supplied
remote dunng autobetical operation.
• If you move to anther area, repeat this procedure
to store stations ill your tlew area.
• For details on tuning the stored stations, see
page 30.
• If you move tile antenna after storing stations with
this procedttre, the s!ored settings may no longer be
valid. If this happens, repeat this procedure to s!ore
the stations again.
(Models of area code CEL, CEK only)
This function lets you store up to 30 FM and
FM RDS stations in alphabetical order without
redundancy. Additionally, it only stores the
stations with the clearest signals.
if you w_mt to store FM or AM stations one by
one, see "Presetting radio stations" on page 30.
1
Press I/_ to turn off the receiver.
2 Hold down MEMORY and press I/_ to
turn the receiver back on.
"AUTO-BETICAL SELECT" appears in
the display and the receiver scans and stores
all the FM _md FM RDS stations in the
broadcast area.
For RDS stations, the tuner first checks for
stations broadcasting the same program,
then stores only the one with the clearest
signal. The selected RDS stations are sorted
alphabetically by their Progr_un Service
name, then assigned a 2-character preset
code. For more details on RDS, see page 31.
Regular FM stations are assigned
2-character preset codes and stored after the
RDS station.
When done, "FINISH" appears in the
display momentarily and the receiver
returns to the norton operation.
You can enter a frequency of the station you
w*mt directly by using the numeric buttons on
the supplied remote. For details on the buttons
used in this section, see pages 36-43.
1
Press TUNER on the remote repeatedly
to select the FM or AM band.
The last received station is tuned in.
2
Press D. TUNING on the remote.
3 Press the numeric buttons to enter the
frequency.
Example 1: FM 102.50 MHz
Example 2: AM 1350 kHz
(You don't have to enter the last "0" when the
tuning scale is set to 10 kttz.)
-®-®-®
If you cannot tune in a station and the
entered numbers flash
Make sure you've entered the right
fi'equency. If not, repeat steps 2 and 3.
If the entered numbers still flash, the
fi'equency is not used in your area.
28 G8