Table of Contents
Advertisement
Chapter 3
Recording
■
Recording Image of Your Portrait Using the Remote Control•
Place the MP-EG lA on the stand and
turn
the camera block so the lens faces you. You
can record yourself using the remote control.
Stand
0
Turn the camera block.
Remote control
(MP-RMIA)
Turn the camera block so the lens faces the same direction
as the LCD monitor does.
e
Install the MP-EG1 A.
Place the stand in a flat, stable position, and install the MP-
EG IA on the stand as shown in the figure.
*
Select a flace where there are no obstacles between you and the
MP-EG A.
If
there is an obstacle between the remote control
and MP-EG lA's infrared receiver, you cannot operate the
MP-
EG lA with the remote control.
*
Be sure to select a stable installation place. Installing the
MP-
EG lA in an unstable place is dangerous.
*
You can use a generally available tripod for a still camera in-
stead of the stand.
*
The stand can be tilted, but cannot be rotated. Do not force to
turn it.
} - Camera block
e
Set the CAM/OFF/PLAY switch to CAM and adjust the angle.
Hold down the red button at the center of the switch and set the switch to CAM. Viewing the LCD
monitor screen, adjust the angle of the stand.
C)
Use the remote control to record.
Point the remote control at the MP-EG IA' s infrared receiver
to operate.
*
A lithium battery must be inserted into the remote control (see
page 27).
*
Be careful that strong light does not strike the infrared receiver.
The remote control distance may be extremely small or no op-
eration can be done.
Infrared
receiver
Within 4 m (Approx. 13
feet) for indoor recording
Advertisement
Table of Contents
