Samsung HP-P5071 Owner's Instructions Manual page 38

This PDVs remote control can operate almost any VCR, cable box or DVD. After it has been set up
properly, your remote control can operate in four different modes :TV, VCR, Cable, DVD or STB_
Pressing the corresponding button on the remote control allows you to switch be_'een these modes,
and control whichever piece of equipment you choose.
N>lc, : _ i_fl_: , female, _:o _'poJ racy _o J e _':o_pa b/e w i'h a// DVD P/cye_s, VCRs, Cable loxes
e 7/e remot_ co_'l;oJ can o/)/opeate S)'}_:i made by Samsung
Setting Up the Remetete Operate YeurVCR, Cablebex er DV[ player
Turn off your VCR. (or Cable box, DVD player}
Press the MODE button. The Mode is changed
whenever MODE button is pressed.
Press the SETbutton on your TV's remote control.
REW
4
Using the number buttons on your remote control,
enter three digits of the VCR (or Cable box, DVD
player) code listed on page 39 of this manual for
your brand of VCR (or CATV, DVD). Make sure you
enter three digits of the code, even if the first digit
Js a "0".
(If more than one code is hsted, try the first one.}
5
Press the POWER button on the remote controk
Your VCR (or CATV, DVD} should turn on if your
remote is set up correctly. If your VCR (or CATV,
DVD} does not turn on after setup, repeat steps
2, 3, and 4, but try one of the other codes listed for
your brand of VCR (or CATV, DVD}.
If no other codes are listed, try each code, 000
through 089 (or Cable box: 000 through 077,
DVD player: 000 through 008}.
ASPECT P.MODE
1
N0fes
o When your remote control is in "VCR" mode, the VCR control buttons (STOP, REW, PLAY!PAUSE, FF)
still operate your VCR.
When your remote control is in "CATV" or "DVD" mode, the VCR control buttons (STOP, REW,
PLAY!PAUSE, FF} still operate your VCR.
You do not need to program the remote for Samsung STBsas the codes are pre-programmed.
38