Philips Norelco G390 User Manual page 8

• If you arc trimming for the first Eirnc, start by
using the AccuControl comb at the maximum
trimming length setting (#9) to prevent
accidentally trimming hairs too short.As you
become familiar with the settings, adjust Hair
Length Selector to desired trimming length.
Selector will "click" Into position at each
setting.
H
Switch the Groomer ON.
□ To trim in the most effective way. move
the Groomer against the direction of hair
growth. Make sure the surface of the Guide
Comb always stays m contact with the skin
tngs).
NO i F~ Since all hairs do not grow m the same
dirertian. you.may want to. try different trimming
directions.. Lie.. .uP.wW^d.o.w.nLWdrci5, .pr-dCgasd..
Practice is best for optimum results.
I If a fot of hair has accumulated in the Guide
Comb, remove the comb and blow and/or
shake the hair out of the comb.You can also
use the cleaning brush provided to remove
hair from the comb area.
I REMEMBER:You must reset the hair length
selector back to your desired setting every
time you replace the guide edmb on the
appliance.
Table 1, Beard Trimmer
Setting Remaining li.iir length
(in.) .'(mm)
I StiAOIe
.00 in/imm
2
Gt{3£«!
1 6 ittZ+n mi
3
Short
4 Medium Short .3i >rUfSmm
5
Med rum
39 in/IOrtrn
6
Medium long
1
Long in/ [ irm
H
Extra Long
63 in/ 16mm
9 Longest
71 Irt/I0rrtr*
I The remaining hair length corresponds wiEh
the smallest distance between the cutting blade
and the spot where the comb is in contact
with the skin.
I Cutting without the comb attachment or
setting the AccuControE guide comb to # I
position, will result in a stubble beard look.