Advertisement
PANEL DESCRIPTION
€ ourput
INPUT €
HYPER
Fuzz
FZ-2
OBOSS
CONNECTIONS
Amplifier
1 AC Adaptor Jack
Connect an AC adaptor ( BOSS PSA-120, 220
or 240 depending on the line voltage system
in your country } to this jack.
* An AC adaptor allows long and secure operation
without worrying about battery life.
* Be sure to use a BOSS PSA-120, 220 or 240
adaptor.Use of any other adaptor may damage the
device.
}— 11
2 Check Indicator
Lights up when the effect is ON, allowing you
to confirm whether the effect is ON or OFF.
* This indicator also serves as the Battery Check
indicator. You will know when the battery has
worn down and needs to be replaced whenever
this indicator goes dim or no longer lights.
3 Level Knob
Used to adjust the volume level of the sound
while the effect is applied. Should be adjusted
so there is no noticeable difference between
the times when the effect is applied and when
the sound is normal.
Connect the AC Adaptor
qui
aoe
4
* Inserting a plug into the Input Jack will
automatically switch the unit on.
* Before connecting or disconnecting a plug,
make sure that the volume of the amplifier is
turned down.
* When the Mode knob is switched to Gain
Boost, this knob will not provide its normal
function.
* With this knob turned all the way to the left,
no sound will be output.
Tone Knob (Treble)
Allow the higher frequency portions to be
boosted/cut. At the center, the tone will be
flat. Boost the higher frequencies by turning
it towards the right (hk ). Turn toward the
left ( 1) to cut them.
Tone Knob (Bass)
Allow the lower frequency portions to be
boosted/cut. At the center, the tone will be
flat. Boost the lower frequencies by turning
it towards the right ( ts }. Turn toward the
left (x8 ) to cut them.
Output Jack
The output from this jack can be connected
to your amp or to another effects device.
AC Adaptor:
BOSS PSA-120,
220 of 240 (option)
7 Pedal Switch
Used to switch effects ON or OFF.
8 Thumb screw
Loosen the screw to open the cover for battery
replacement. For a detailed explanation, see
"BATTERY REPLACEMENT"
9 Mode Selection Knob
Allows you to select the function you wish
your FZ-2 to perform.
FUZZ 1
A basic fuzz sound that places
emphasis on the harmonics.
FUZZ 2
A full-bodied fuzz sound that
places emphasis on the lower
frequency range.
GAIN BOOST
Ideal for boosting the power of
a guitar with limited output
power (such as one with a
single-coil
pickup);
or for
increasing
the
amount
of
distortion you can obtain when
using a distortion-type effects
units or guitar amplifier.
10 Gain Knob
[When FUZZ 1 or FUZZ 2 is selected]
Allows you to adjust the depth of the fuzz. The
distortion depth is increased (and sustains will
be lengthened) as you move the knob to the
right").
{When GAIN BOOST is selected}
Allows you to adjust the amount by which the
gain is to be boosted. The gain is increased the
more you move the knob to the right (. *).
* Oscillation could be produced if the depth is
increased too much.
11 Input Jack
Here is where you need to connect your
guitar, or other electric/electronic instrument.
* The Input Jack is equipped with a power switch,
Whenever you insert a plug into it, the power is
turned ON. Pull the plug out, and the power goes
OFF. For this reason, try to make a habit of pulling
out the cord going to the Input Jack whenever the
pedal is not being used.
Advertisement
