Rear Panel Description And Functions - VocoPro KJ-7800 PRO User Manual

Rear Panel Descriptions
and Functions Cont...
9. PHONO/LINE switches
use the accompanying switch. Select the out position to toggle to PHONO and the in position to toggle to
LINE input type.
10. CD INPUT 1, 2, 3
cables. Adjust the STEREO CHANNEL SOURCE toggle on the middle panel of the KJ-7800
accordingly.
11. MICROPHONE INSERTS - These jacks are for connecting out-board effects units. The audio from
the MIC channels are routed out from the INSERT jacks to your out-board effects unit(s) and routed back
with the effects applied, using only a single cable. In order to use these jacks, you will need appropriate
TRS (tip = send, ring = return, sleeve = signal ground) insert cables.
12. VOLTAGE SELECTOR - This switch can change the voltage from 115V to 230V. Before your KJ-
7800 Pro is shipped from the factory, the switch is set to 115V. If you live in an area that has different
voltage requirements (230-240V), you MUST set it to 230V.
13. GROUND LIFT switch - A "ground loop" is a phenomenon where an unintended connection to ground
is made through an interfering electrical conductor, causing what is known as "60Hz hum." A GROUND
LIFT switch adds a resistor between the ground and cable shield when switched on, effectively ridding the
system of hum.
14. GROUND TERMINALS - These TERMINALS are for connecting ground wires. If you are experiencing
line noise, attach wire from here to your other devices or similar suitable surface.
15. VIDEO OUT 1, 2, 3 - These jacks send graphics from input source player video output to video dis-
play device(s) such as TVs, TFTs and Monitors. Connect video cables from these VIDEO OUT jacks to the
VIDEO IN jacks on your video display device(s).
16. VIDEO IN 1, 2, 3 - These jacks allow the video component of CD+G, DVD, VCD and LD players to be
connected to the KJ-7800 Pro. Connect video cables from the VIDEO OUT jacks on your player(s) to these
VIDEO IN jacks.
17. REMOTE KEY CONTROL - This 1/8" jack is for connecting a REMOTE KEY CONTROL cable. Remote
Key Control allows you to make key changes at a distance from the Digital Key Controller on the KJ-7800.
BOOTH OUT
A C INPUT
12
13
GN D
LIFT
- When inputing turntables to the PHONO/LINE 1 or 2 STEREO INPUT jacks,
-
Use these dedicated inputs for CD players as source music with RCA L/R
MASTER OUT
REC OUT
U N B A L
RECOR D
B alanced
14
GND
VIDEO OUT
15
AV INPUT STEREO INPUT
AV OUT
PHONO 2
A U D IO AV3 AV2 AV1 PHONO 3 C D 3
LINE
remote
key control
VIDEO IN
17
16
15
10
MICROPHONE INSERTS
PHONO 1
C D 2 C D 1
LINE
4
PHONO
LINE
9
11
3 2 1