Table of Contents
Advertisement
Getting Started
See the Important Safety and Product Information
guide in the product box for product warnings and
other important information.
Installing the Memory Card
The camera requires a microSD™ or microSDHC
memory card from 4GB to 64GB with a speed of
class 10 or higher. Please visit
support#GDRTab
for compatible memory card list.
You can use the included memory card, or you can
purchase a compatible replacement memory card from
an electronics supplier.
1 Insert the memory card
2 Press it in until it clicks.
Removing the Memory Card
Removing the memory card while the device is turned
on can result in a loss of data or damage to the device.
1 Turn off the device.
2 Press the card in until it clicks.
3 Release the card.
The card ejects from the slot.
Device Overview
Press to turn the device on.
Hold for 3 seconds to turn the device
1
off. Select to return to the previous
page.
Select to scroll through menus or pages.
2
Select to scroll through menus or pages.
3
GDR E530/E560
WARNING
Garmin.com.sg/sd-
into the slot
2
.
1
NOTICE
From the viewfinder, select to save a
photo. Hold to save a video clip.
4
Select to choose an option in a menu.
Installing the Mount onto Your Windshield
The adhesive mount is extremely difficult to remove
after it is installed. You should carefully consider the
mounting location before you install the mount.
Before you can install the adhesive mount onto your
windshield, the ambient temperature must be from 21°
to 38°C (from 70° to 100°F).
TIP: You can connect the device to power and hold the
device in the preferred mounting location to check the
camera's field of view at that location.
1 Clean the windshield using water or alcohol, and a
lint-free cloth.
The windshield must be free of dust, wax, oils, or
coatings.
2 Remove the protective film from the mount
adhesive.
3 Position the mount over the mounting location.
TIP: The adhesive is extremely sticky. Do not touch
the adhesive to the windshield until the mount is
properly positioned and aligned.
4 Press the mount firmly onto the windshield, and
maintain pressure for 30 seconds.
5 Pull the camera and mount away from the
windshield.
NOTICE
1
Advertisement
Table of Contents
