Table of Contents
Advertisement
8.7 Stain/Prewash
Press this button repeatedly to activate one of
the two options.
• Stain
Select this option to add an anti-stain
phase to a programme in order to treat
heavily soiled or stained laundry with stain
remover.
Pour the stain remover into compartment
. The stain remover will be added in
the appropriate phase of the washing
programme.
This option can increase the
programme duration and is not
available with a temperature lower
than 40 °C.
• Prewash
Use this option to add a prewash phase at
30 °C before the washing phase.
This option is recommended for heavily
soiled laundry, especially if containing
sand, dust , mud and other solid particles.
This option can increase the
programme duration.
The corresponding indicator above the
touch button illuminates.
8.8 Rinse
With this button you can select one of the
following options:
• Extra Rinse option
This option adds a few rinses according to
the selected washing programme.
Use this option for persons allergic to
detergent residues and in areas where the
water is soft.
This option increases slightly the
programme duration.
• Skipping wash phase - Only Rinse option
The appliance performs only the rinsing
phase, the spinning and the draining
phases of the selected programme.
The corresponding indicator above the touch
button illuminates.
8.9 Steam Finish
This option adds a steam phase followed by a
short anti-crease phase at the end of the
washing programme. The steam phase
reduces fabric creasing and facilitates the
fabric ironing.
The indicator
flashes on the display during
steam phase.
The drum performs smooth movements for
about 30 minutes. The duration of the steam
phase changes accordingly to the selection.
When Plus Steam option is set the
programme ends up with an anticrease phase
during which the drum is occasionally rotated
to prevent wrinkling. The display shows
indicator
is steady on and the indicator
starts flashing. Start/Pause button is lit as
well. At the end of the anticrease phase the
drum definitely stops, the indicator goes off,
the door unlocks. User at any moment can
terminate the anticrease phase by:
• pressing the On/Off button for a few
seconds to activate or deactivate the
appliance;
• turning the selector knob to another
position.
A small laundry load helps to reach better
results.
8.10 Delay Start
With this option you can delay the start of a
programme in a more convenient time.
Touch the button repeatedly to set the
required delay. The time increases by steps
of 30 minutes up to 90' and from 2 hours up
to 20 h.
After touching the Start/Pause button, the
display shows the indicator
selected delay time and the appliance begins
the countdown.
the
and the
ENGLISH
19
Advertisement
Table of Contents
