Advertisement
Available languages
Available languages
Problem
Mains indicator
light does not go on
; Dishwasher refuses
'- to start
iDicrineaae stops
at wash cycle
Dishwasher does not
empty
Detergent dispenser
lid will not close
Lower spray arm
rotates with difficulty —
White deposits left
on dishes —
_ Streaks on glassware
Utensils still wet after drying
Rattling noises
Unsatisfactory
washing results
Immediately upon refill the
salt refill sign will still show
26
Possible cause
"= Themain switch has not been turned.
- Appliance not plugged in. |
- A fuse is blown in the house mains.
- Programme selector not turned to
- beginning of programme, a number.
.
- Door of appliances not securely closed.
- Water tap not turned on.
~ Filter in water inlet hose is clogged. -
~ Strainer is clogged.
(check the combined coarse/fine Strainer - Fig. 0/33,
— Programme sequence not yet over. _
- Remove spray-arm and clean.
- Clean also spray-arm's bearing.
— Incorrect dosage of detergent or rinse-aid.
— No granular salt in the water softening unit.
.
Adjust water hardness regulator (Fig. €/13 and ¢ Ne
to a higher setting.
— The lid of the granular salt container is not
properly closed.
- Too much rinse-aid.
- Too little rinse-aid.
- Utensils not properly arranged.
- Incorrect dosage of detergent or rinse-aid.
- Programme selector turned accidentally after filling
detergent container - This releases detergent
at a too early stage.
- Utensils incorrectly arranged or basket overloaded.
- Spray-arm rotation obstructed by utensils.
- Combined coarse/fine strainer is clogged (Fig. @/33).
'~ Microfilter (Fig. ©/34) is clogged.
If necessary, remove and clean. When re-inserting micro-
filter make sure that it clicks securely back into place.
- Strainer's rim._not properly fitted into depression.
- Nozzles in spray-arm are blocked.
—
- Selected programme not intensive enough for level .
of soiling.
:
- The lid of the salt container was closed too abruptly
"(open again and reclose gently)
Advertisement
