Samsung S49C95 U Series User Manual page 32

2nd 3rd
Input Port Ver.
Auto Source Switch+ Auto Source Switch+
USB-C Switch
Key Repeat Time
Power LED On
Description
Select an HDMI version.
― The supportable device and resolution may differ depending on its version.
― When the version is changed, the screen may blink.
― If you set the HDMI Mode to 1.4, some high resolutions may not be supported because of bandwidth limitation of the HDMI 1.4 protocol.
― When the setting is not appropriate, a blank screen may appear. In this case, check the specifications of the device.
By activating, a new connected source is displayed automatically.
― This function may not be supported depending on the model or geographical area.
When there is no signal, the display automatically switches to the new device connected to the USB-C port.
Control the response rate of a button when the button is pressed.
Acceleration, 1 sec or 2 sec can be selected. If
Configure the settings to enable or disable the power LED located at the lower part of the product.
• Working: The power LED is on when the product is turned on.
• Stand-by: The power LED is on when the product is turned off.
No Repeat is selected, a command responds only once when a button is pressed.
32