Table of Contents
Advertisement
deSetting up and connecting
4 Set up and
Connect
To ensure proper operation, connect
the device to electricity and water
properly. Please note the required
criteria and the assembly
instructions.
4.1 Scope of delivery
After unpacking, check all parts for
transport damage and that the
delivery is complete.
If you have any complaints, please
contact the retailer where you
purchased the device or our customer
service.
A notice:The device was checked at the
factory to ensure that it is working
properly. This may leave water stains
on the device. The water stains
disappear after the first rinse.
The delivery consists of: ¡
dishwasher
¡Instructions for use
¡assembly Instructions
¡Further information documents ¡
Mounting material
¡Steam protection plate
¡Salt filling aid funnel ¡
Power cord
¡quick start Guide
4.2 Set up and connect the
device
You can install your under-counter
device or integrated device in the
kitchen unit between wooden walls
and plastic walls. If you subsequently
set up your device as a free-standing
device, you must secure your device
against tipping over, e.g. B. through
screw connections on the wall or
through installation under a
12
adjacent worktop, which is firmly
connected to the neighboring
cupboards.
Follow the safety instructions.
1.
→ page 4
Follow the instructions for electrical
2.
connection.
Check the scope of delivery and
3.
the condition of the device.
The required installation dimensions can be
4.
found in the assembly instructions.
Set up the device horizontally using
5.
the adjustable feet.
Make sure you have a secure footing.
Install the wastewater connection.
6.
→ page 12
Install the drinking water
7.
connection. → Page 13
Connect the device to power.
8th.
4.3 Waste water connection
Connect your device to a wastewater
connection so that water
contaminated by the rinse cycle can
drain away.
Install waste water connection
Please refer to the assembly
1.
instructions provided for the
necessary steps.
Connect the waste water hose to
2.
the drain connection of the siphon
using the included parts.
Make sure that the drain hose is not
3.
kinked, crushed or twisted.
Make sure that there is no cover in
4.
the drain that prevents the waste
water from flowing out.
Advertisement
Table of Contents
