Start Program; Interrupting The Program; Cancel Program - Bosch SMV2ITX23E Instructions For Use Manual

Hide thumbs Also See for SMV2ITX23E:
Table of Contents

Advertisement

Press the button for the
appropriate additional function.
"Additional functions", page 20
aThe additional function is set
and the additional function button flashes.
14.4 Setting the time delay
You can delay the start of the program
by 3, 6 or 9 hours.
Press repeatedly until the
1.
corresponding display lights up.
To activate the time delay, press .
2.
A notice:You can deactivate the time
delay by pressing until none of the 3h,
6h or 9h displays light up.

14.5 Start program

press.
aDuring the program run
A point of light is projected on the
floor below the appliance door.
When installed high with a flush
furniture front, the light point is not
visible.
aThe program is finished when
no displays on the control elements
light up.
aIf the light point on the floor
is no longer visible, the program is
finished.
Hints
¡If you during operation
If you want to add more dishes, do
not use the tab drip tray as a handle
for the upper dish rack. You might
come into contact with the partially
dissolved tab.
Depending on the device equipment
1
¡You can view the current program
Only change the program if you
cancel the program.
→ "Cancel program", page
33
¡To save energy, switch
The device switches off 1 minute after
1
the end of the program. If you open the
device door immediately after the end
of the program, the device switches off
after 4 seconds.
14.6 Interrupt program
A notice:If you open the appliance door
when the appliance is heated up, leave the
appliance door ajar for a few minutes and
then close it. This will prevent excess
pressure from building up in the device
and causing the device door to pop open.
Open the device door carefully.
1.
press.
2.
aThe program is saved
and the device switches off.
To continue the program, press .
3.
Close the device door.
4.

14.7 Cancel program

To end a program prematurely or to
change a program that has been
started, you must cancel it.
Open the device door.
1.
2.
press.
Close the device door.
3.
aThe program is aborted
and is completed after approx. 1
minute.
Basic operationde
approx. 4 seconds
33

Advertisement

Table of Contents
loading

Table of Contents