Programming The Playingorderofthe Tracks --Program Play - JVC HX-Z30 Instructions Manual

Programming the PlayingOrderofthe Tracks
--Program Play
You can arrange the playing order of the tracks before you
start playing. You can program up to 100 tracks.
• To use Repeat Play (see page 19) for Program Play, press
REPEAT after starting Program Play. Only REPEAT 1 and
REPEAT ALL can be selected for Program Play.
• There is a time limit in doing the following steps. If the setting
is canceled before you finish, start from step 2 again.
1
Load discs.
• If the current playing source is not the CD player, press
CD I_/11,
then • before going to the next step.
2
Activate Program Play.
On the unit:
Press CD PLAY MODE repeatedly C0PLAYMODE
until "CD PROGRAM" appears
on the display.
•
Each time you press the button, the
play
mode
changes as
follows:
total playing time (Continuous Play)
On the remote control:
Press PROGRAM so that
"CD PROGRAM" appears
on the display.
The PROGRAM indicator lights up on the display.
h 4
PP BPR,,
• If a program has been stored in memory, the program is
called up.
3 Press one of the disc number buttons (CD1 -
CD5) to select the disc you want.
cm -- A co2 -- A CD_ -- A e_ -- A cos -- A
Track number Program step number
Disc number
4
Select a track from the selected disc in
step 3.
• Program step numbers exceeding 100 cannot be
programed.
• When making programs from MP3 discs, the unit only
recognizes tracks like audio CD. You cannot make
programs using group numbers.
On the unit:
Turn _1 / 1_14 to
select the track
number, then
press
SET/DISPLAY.
SET
/DISPLAY
On the remote control:
Press the number buttons.
• Pk_r how to use the number buttons,
see "To go to another track directly
using the number buttons" on page
16.
@@@
@@@
@@@
r t
OQ{D
5
6
Program
other tracks you want.
• To program tracks from the same disc, repeat step 4.
• To program tracks from a different disc, repeat steps 3
and 4.
Press CD _/11. I[ .....
The tracks are played in the order you
have programed.
• If the playing disc is an MP3 disc, the MP3 indicator
lights up.
To stop playing, press •.
To exit from Program Play, press CD PLAY MODE
repeatedly until the PROGRAM indicator goes off (or press
PROGRAM on the remote control) after playback stops.
• If you try to program a 101st track, "CD FULL" appem_ on Ihe
display.
• If you have tried to program a track from an empty tray, "NO
READ # (nmnber)" or "NO DISC # (number)" will appear on the
display for 2 seconds.
• If yon have tried to program a track number that does not
exist, it is ignored.
• If you try to open a disc tray during Program Play, the disc
tray does not come out. Open disc trays after canceling Program
Play.
17