Specifications; Fcc Warning - Kenwood DP-2060 Instruction Manual

Specifications
a
[Format]
System .........:ccc0 Compact disc digital audio system Channel! separation ........cccc-:cccessseeees More than 83 dB
Number of channels .................:sesccsesssersenes 2 channels Output level/impedance
playing rotation ................00008 200 rpm ~ 500 rpm (CLV) FAO gos sac ciccd decid scochaedeadeadvanitastuavascc succes 2.0V/3.3kQ
Headphone output............. Sodeccnsdeststivaisczecceais 6mW (32Q)
(D/A Convertors]
D/A Conversion .......- dn $i tnssécnesenevesvevedes sonsiesssettesastoues 1 Bit [General]
[Audio] H: 106 mm {4 - 3/16")
Frequency response ...........-...-..- 8 Hz ~ 20 kHz + 1.0 dB BD: 310 mm (12 - 3/16")
DyMamic range ..........cccceccssessrscsssscsseses More than 92 dB
Total harmonic distortion................. Less than 0.005%
Note:
KENWOOD follows a policy of continuous advancements in development. For this reason specifications may be changed without notice.
For the U.S.A.
FCC WARNING |
This equipment may generate or use radio frequency energy. Changes or modifications to this equipment may cause harmful interference unless
the modifications ere expressly approved in the instruction manual. The user could lose the authority to operate this equipment if an unauthorized
change or modification is made.
NOTE
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits
are designed to provide reasonable protection against harmful interference in a residential installation. This equioment may cause harmful
interference to radic communications, if it is not installed and used in accordance with the instructions. However, there is no guarantee that
interference will not occur in a particular installation. If this equipment does cause harmful! interference to radio or television reception, which can
be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or moreof the following measures:
— Reorient or relocate the receiving antenna.
—— Increase the separation between the equipment and receiver.
— Connect the equipment inte an outlet on a circuit different from that to which the receiver is connected,
— Consult the dealer or an experienced radia/TV technician for help.
DP-2060/59-1060 (En) 414