Singer 15-91 Instructions For Using Manual page 22

62
To Pipe a Ruffle
(1) Insert the material to be ruffled between the two
blue blades Line 3, Fig. 67. This material must
not exceed 114 inches in width.
180924
Fria. 67. Correcr Positions ror THE MATERIALS
(2) The piping material is usually cut on the bias and
it should be about 14 inch wide when folded in
the center. Place the piping material in the
ruffler, following Line 5, Fig. 67 with the folded
edge of the piping to the right.
Fie. 68. Pretne A Rurrce
(3) Fold the edge of the material to which the piping
and ruffling are to be attached and insert it in
the ruffler, following Line 6, Fig. 67.
63
To Adjust the Ruffler for Plaiting
(1) Raise the adjusting lever E and move it until the
projection D can be entered in the slot marked
"6", The ruffler will then plait once every six
stitches. To plait once every 12 stitches, have
the projection D enter the slot "12" in the
adjusting lever E.
64
To Adjust the Ruffler for Group Plaiting
(1) To make the space between the groups of plaits,
raise the adjusting lever E and move it until
the projection D can be entered in the small
slot indicated by the star on the adjusting lever
E. The ruffler will then stop plaiting and plain
stitching will be made.
Fie, 69. PLaiTine wits THE Rurrier
(2) Insert the material to be plaited between the two
blue blades Line 2, Fig. 70.
MATERIAL
Fig. 70. Correct Position ror THE Matera
(3) To increase the width of plait, move the adjust-
ing finger F back toward the needle and turn
the adjusting screw C downward. To make a
smaller plait, turn the adjusting screw C up-
ward. The distance between plaits is regulated
by the length of stitch.
Fig. 71. Group Piarrine with tHE RurFLER
(2) When the desired space is made, set the projec-
tion D in either of the slots "6" or '12".
(3) Insert the material to be plaited between the two
blue blades Line 2, Fig. 72.
Fig, 72, Correct Posttron ror THE Marerrat
To Oil The Ruffler
Occasionally apply a drop of oil to the working
parts of the ruffler at each of the places indicated
in Fig. 71.