Opel Vivaro C 2023 Manual page 261

11. Set the rocker switch on the
compressor to I. The tyre is filled
with sealant.
12. The compressor pressure gauge
briefly indicates up to
600 kPa (6 bar) whilst the sealant
cartridge is emptying (approx.
30 s). Then the pressure starts to
drop.
13. All of the sealant is pumped into
the tyre. Then the tyre is being
inflated.
14. The prescribed tyre pressure
should be obtained within ten
minutes.
Tyre pressure 3 283.
When the correct pressure is
obtained, switch off the
compressor.
If the prescribed tyre pressure is
not obtained within ten minutes,
remove the tyre repair kit. Move
the vehicle one tyre rotation.
Reattach the tyre repair kit and
continue the filling procedure for
ten minutes. If the prescribed tyre
pressure is still not obtained, the
tyre is too badly damaged. Seek
the assistance of a workshop.
Drain excess tyre pressure with
the button on the air hose.
Do not run the compressor longer
than ten minutes.
Vehicle care
15. Detach the tyre repair kit. Remove
sealant bottle from compressor.
Screw the filler hose to the free
connection of the sealant bottle.
This prevents sealant from
escaping. Stow tyre repair kit.
16. Remove any excess sealant
using a cloth.
17. Continue driving immediately so
that sealant is evenly distributed
in the tyre. Drive between
20 km/h and 60 km/h. After driving
approx. 5 km but no more than ten
minutes, stop and check tyre
pressure. Screw compressor air
hose directly onto tyre valve when
doing this. Fill tyre as described
before. Drain excess tyre
pressure with the button on the air
hose.
If tyre pressure hasn't decreased
under 200 kPa (2 bar), set it to the
correct value. Otherwise the
vehicle must not be used. Seek
assistance of a workshop.
Repeat the checking procedure
once more after driving further
10 km but no more than ten
259