Table of Contents
Advertisement
I
20
NSTALLATION
3.
Turn on the scanner power.
The status light comes on and flashes indicating that the scanner is receiving power.
If you are using Windows version XP or later, and have plugged the USB cable into a USB 1.1 port,
an information bubble may open explaining that "A HI-SPEED USB device is plugged into a non-
HI-SPEED USB hub". Plug the USB cable into a USB 2.0 port (if available) or just disregard the
message. If you leave it plugged into the USB 1.1 port, your scanner may scan a bit slower.
Your computer then recognizes that a scanner has been plugged into the USB port and automatically
loads the appropriate software to run the scanner.
If your computer is running Windows version XP or later, you will see a message similar to the following.
Advertisement
Table of Contents
