Sony Handycam CCD-TR99 Operation Manual page 53

Remote Control Direction
Aim till- Uomolo Comm.iiiJi'r to llio romoti- sensor within tlie r.ins;e .is sliown below
Notes on the Remote Commander
• Keep the remote sensor away from strong light sources such as direct sunlight or illumination.
Otherwise, the remote control may not be effectir e.
• Be sure that there is no obstacle between the remote sensor on the camcorder and the Remote
Commander.
• This camcorder works at commander mode VTR 2. The commander modes (1, 2, and 3) are used to
distinguish this camcorder from other Sony VCRs to avoid remote control misoperation. If you use
another Sony VCR at commander mode VTR 2, we recommend you change the commander mode
or cover the remote sensor of the VCR with black paper.
To Watch the Demonstration
You can watch a brief demonstration of pictures with titles.
If the demonstration appears when you turn on the camcorder for the first time, exit the Demo mode
to use your camcorder.
To enter Demo mode
(1) Eject the cassette and slide the POWER switch to OFF.
(2) Turn STANDBY up.
(3) While holding down ► PLAY, slide the POWER switch to CAMERA. Demonstration starts. The
demonstration stops when you insert the cassette.
Note that once you enter Demo mode, this mode is retained as long as the lithium battery is in place.
Therefore, demorrstration starts automatically 10 minutes later every time you slide the POWER
switch to CAMERA, or after you eject the cassette.
To exit Demo mode
(1) Slide the POWER switch to OFF.
(2) Turn STANDBY up.
(3) While holding down ■ STOP, slide the POWER switch to CAMERA.
53