Visioneer OneTouch 9000 Installation Manual page 49

A
DJUSTING THE
To use the pointer to drag the line, make sure the pointer button is
selected at the top of the window.
4. When the trimmed area is what you want, click Scan.
To manually set the output size for an item:
1. To scan the entire item on the glass, click Same as Original. No
sections are trimmed.
2. To set the output size yourself, click Same as Original to remove
the checkmark.
The settings for the output size become active.
3. Put the pointer on the image and drag the mouse to enclose the
section you want in the scanned image.
As you drag the mouse, a dotted box appears on the image and the
size settings change to reflect the new output size area. You can also
type in the size settings boxes.
Width and Height—the measurements of the final image after
I
it's scanned; for example, if you plan to print the image on a
typical piece of paper, the width and height are 8.5 and 11.0
inches
Units—units of measurement for the new area; click the drop-
I
down arrow and choose new units if you want
Resolution—the dots-per-inch (dpi) setting for the new area
I
Scale—the amount of enlargement or reduction of the image to
I
fill the width and height measurements; for example, if you select
a small area and have set the width and height to a paper size, the
scale automatically increases to enlarge the small image so it's the
same size as the paper
A new Scan Info box on the lower left portion of the Scan Manager
Pro shows the information for the new area.
You can select multiple areas. A new Scan Info box appears for each
one.
The following figure shows an example of a manually selected area.
S S M
ETTINGS ON THE CAN
P 45
ANAGER RO