Table of Contents
Advertisement
System Monitoring
7.4 CREATING A NEW SETUP
The = command is used to create a new list of traces that are to be scanned. Each trace requires one or
more of the following specifications:
e The function to be measured (see subsection 7.1, "Measurement Choices").
oe The number of digits of resolution to be used by the HP 3421A.
e The temperature units (C, F, K, or R).
oe The conversion subprogram to be called, if needed.
e Up to five limit tests.
When Hew is selected the program prompts for the number of traces in the new setup.
If a setup is
currently defined, the program asks if the setup may be destroyed.
Get
Hew Save Ver
Main
Destroy setup
CYoHIT
[Y] or NI
Screen bit le
screen title ENDLINE
Humber of
traces?
number of traces ENDLINE
# #%
Trace
1
%
#%
trace label ENDLINE
The file menu.
Press
to select the Hz command.
If a setup is currently defined, the program asks if the
setup may be destroyed.
Press
to proceed with the new setup, or [N] to escape
back to the file menu.
The program prompts for the title to be centered at the
top of the monitor screen.
Enter the title, up to 80 characters, and press ENDLINE J .
The program prompts for the number of traces to be
scanned.
Enter the number of traces, up to 18.
The program displays the number of the trace being
entered.
The program prompts for the trace label. This is the label
that will appear on the video display, so be sure that it will
be understandable.
Enter the trace label, up to 20 characters.
7-5
Advertisement
Table of Contents
