Advertisement
TO PLAY ONLY DESIRED TRACKS/DISCS (Program Playback and Delete Program Playback)
Programming a pause
| To check the program contents
inserting @ pause in your program can be very useful when carrying
out recording. Press i instead of entering a track number.
"PA"
appears on the display panel.
®
For example, when recording on both sides of a cassette tape,
if you program a pause after the last track to be recorded on
the first side, program playback will pause at that point to allow
you to switch tape sides. To resume program playback after the
player enters pause mode, press Hl.
NOTES:
®@ A pause can be prograrmmed only when the program procedure
is performed under stop mode.
@ A pause cannot be programmed at the beginning of a program
{P-01), nor can two pauses be programmed one after the other.
@
A pause inserted in a program is counted as one step.
@
If a pause is programmed as the last step of a program, the
player will not enter the pause mode.
To clear all of the program contents
@®:
®
During stop mode, press a.
When the magazine is ejected, the program contents of the
ejected magazine will be cleared.
To erase a program
al
CLEAR
CLEAR
During program mode, press CLEAR.
The last program step is erased and the contents of the previous
program step are displayed.
NOTE:
Contents of a program ean be erased during playback as well.
However, tracks preceding the currently playing track cannot be
erased in this way.
During program mode, set the player to stop mode and press
CHECK. The program contents will be displayed in the programmed
order.
e
After confirming the last programm step, the display will show
"00-00: ".
DISC NUMBER,
TRACK NUMB!
1. During program mode, set the player to stop mode and press
CHECK
so that the program step to be corrected appears on
the display.
2. To correct the magazine No., enter the new magazine No. with
MAGAZINE. To correct the disc No., enter the new disc No
with the DISC number buttons.
To correct the track No., enter
the new track No. with the Digit buttons.
For example, the
programmed track No. 9 on the disc No. 1 in the magazine No
1 is changed to track No. 2 on the disc No. 2 in the magazine
No. 2, using MAGAZINE 2, DISC 2 and digit button 2
@
Repeat steps 1 and 2 to change other tracks as desired.
@
To change the track No. with Hé< << o7 i
mii, be sure to
press PROGRAM.
About 2 seconds have passed since ke
~<¢-4 OF Be
Pi
is pressed, the track No. to be changed is
automatically entered.
17
<PRB1188>
En
Advertisement
