Bosch Professional GBR 15 CAG Original Instructions Manual page 9

Always wear protective goggles, hearing protection, a
u
dust mask, protective gloves and sturdy shoes while
working. If necessary, also wear an apron.
Remove the diamond grinding head before transport-
u
ing the power tool to avoid damage.
To obtain the best working results, grind only with low
u
pressure; do not tilt, knock, or penetrate the material.
Diamond grinding heads can get very hot during work;
u
do not touch them until they have cooled down.
Only place the power tool down when the diamond
u
grinding head has come to a complete stop.
Use the two-hole spanner to tighten and loosen the
u
clamping nut 3 607 950 017.
Observe valid national and international standards.
u
Product Description and
Specifications
Read all the safety and general instructions.
Failure to observe the safety and general in-
structions may result in electric shock, fire
and/or serious injury.
Please observe the illustrations at the beginning of this oper-
ating manual.
Intended Use
The power tool is intended for dry grinding, deburring and
smoothing mainly mineral materials (such as concrete,
stone, marble and screed). It is also suitable for removing
protective coating and adhesive residue. The power tool may
Technical Data
Concrete grinder
Article number
Rated power input
Power output
Rated speed
Diamond cup wheel diameter
Grinding spindle thread
Soft start
Restart protection
Starting current limitation
Constant electronic control
Overload protection
Grinding close to edges
Weight according to EPTA-Procedure
01:2014
Protection class
The specifications apply to a rated voltage [U] of 230 V. These specifications may vary at different voltages and in country-specific models.
Bosch Power Tools
be used only in conjunction with a diamond cup wheel and a
dust extractor of dust category M.
Product Features
The numbering of the product features refers to the diagram
of the power tool on the graphics page.
(1) On/off switch
(2) Auxiliary handle (insulated gripping surface)
(3) Protective guard and extraction hood
(4) Two-part brush collar (GBR 15 CAG)
(5) Opening (GBR 15 CAG)
(6) Movable part of the protective guard
(GBR 15 CAG)
(7) Locking device (GBR 15 CAG)
(8) Extraction outlet
(9) Spindle lock button
(10) Extraction hose
(11) Brush collar (GBR 15 CA)
(12) Handle (insulated gripping surface)
(13) Grinding spindle
(14) Mounting flange with O‑ring
(15) Diamond cup wheel
(16) Clamping nut
(17) Quick-clamping nut
Two-pin spanner for clamping nut
(18)
A) Accessories shown or described are not included with the
product as standard. You can find the complete selection of
accessories in our accessories range.
GBR 15 CAG
3 601 G76 0..
W 1500
W 820
-1
min 9300
mm 125
M 14
kg
English | 9
A)
A)
A)
GBR 15 CA
3 601 G76 0..
1500
820
9300
125
M 14
●
●
●
●
●
●
2.6 2.6
/ II
1 609 92A 5SZ | (27.08.2020)
●
●
●
●
●
−
/ II