Viking VRBD140T Use & Installation Instructions Manual
  1. Manuals
  2. Brands
  3. Viking Manuals
  4. Beverage Dispenser
  5. VRBD140T
  6. Use & installation instructions manual
Viking VRBD140T Use & Installation Instructions Manual

Viking VRBD140T Use & Installation Instructions Manual

Vrbd/vubd 24” w. beverage dispenser
Hide thumbs Also See for VRBD140T:
Table of Contents

Advertisement

Quick Links

Download this manual
USE/INSTALLATION
INSTRUCTIONS
VRBD/VUBD 24" W. BEVERAGE DISPENSER
Retain for Future Reference
IMPORTANT - PLEASE READ AND FOLLOW
•Before beginning, please read these instructions completely and carefully.
•Do not remove permanently affixed labels, warnings, or plates from the product. This may void the warranty.
•The installer should leave these instructions with the consumer for future reference.

GENERAL INFORMATION

1. A A L L W W A A Y Y S S connect CO2 gas cylinder to reducing valve or regulator
2. N N E E V V E E R R connect gas cylinder directly to keg.
3. A A L L W W A A Y Y S S secure gas cylinder in upright position.
4. A A L L W W A A Y Y S S keep gas cylinder away from heat.
5. N N E E V V E E R R drop or throw gas cylinder.
6. A A L L W W A A Y Y S S ventilate after CO2 leakage.
7. Gas cylinders should be stored in the coolest part of the room, preferably at 70
upright position before the primary regulator is attached to the cylinder
CO
CAN BE DANGEROUS
2
If it becomes difficult to breathe and
your head starts to ache, abnormal
concentrations of carbon dioxide may
be present in the area. Leave the
room immediately.
B B E E E E R R D D I I S S P P E E N N S S I I N N G G K K I I T T C C O O N N S S I I S S T T S S O O F F : :
•Draft Tower Assembly
•Drain Hose
•Drain Container
•Keg Coupler
•Air Line with Clamps
•Single Gauge Regulator
•Filled 5 lb. CO 2 Cylinder
T T O O O O L L S S N N E E E E D D E E D D : :
•Crescent Wrench
•Pliers
•Screwdriver
Draft Tower
Assy
Beer Line
VIKING RANGE CORPORATION
111 Front Street
Greenwood, Mississippi 38930 USA
(662) 455-1200
o
F., and securely fastened in the
Regulator
Keg Coupler
Pressure
(Sankey type
Gauge
shown)
Air
Line
Toggle Shut
Off Valve
Regulator
Coupling Nut
Drum Valve
Set Screw
CO 2 Tank
41006170 Rev. F

Advertisement

Table of Contents
loading

Related Manuals for Viking VRBD140T

Summary of Contents for Viking VRBD140T

  • Page 1: General Information

    T T O O O O L L S S N N E E E E D D E E D D : : •Crescent Wrench •Pliers •Screwdriver VIKING RANGE CORPORATION Greenwood, Mississippi 38930 USA F., and securely fastened in the Draft Tower...

  • Page 2: Built-In Installation

    Proper Disposal of Your Old Refrigeration Product Suffocation Hazard Remove doors from your old refrigerator. Failure to do so can result in child entrapment, which can cause death or brain damage I I M M P P O O R R T T A A N N T T : : Child entrapment and suffocation are not problems of the past.
  • Page 3 CASTERS Your beverage dispenser is equipped with four casters. the front two casters can be locked. For built-in applications, the four casters can be removed by removing the nut located inside the dispenser cabinet and then pulling the threaded caster spindle through the base of the unit.
  • Page 4 DIMENSIONS - FREESTANDING MODELS FRONT 24 5/8” (62.5 cm) 24” (61.0 cm) 12 5/16” (31.3 cm) SIDE 2 1/16” (5.2 cm) 41 25/32” (106.2 cm) 2 3/8” (6.0 cm) 2 1/2” (6.4 cm) 25 1/8” (63.8 cm) 12 7/8” (32.7 cm) 13 3/4”...

  • Page 5: Undercounter Models

    CABINET CUTOUT - UNDERCOUNTER MODELS *Actual dimension of drain pan is 12” x 5” (30.5 cm x 12.7 cm) This area should be cut 12 3/16” x 5 3/16” (31.0 cm x 13.2 cm) for clearance 24” (61.0 cm)* Min. 34 1/8” (87.9 cm Max.
  • Page 6 DIMENSIONS - UNDERCOUNTER MODELS FRONT 23 7/8” (60.7 cm) 30 3/4” (78.1cm) 24 3/8” (61.9 cm) 5” (12.7 cm) SIDE Min 34” (86.4 cm) Max 35” (88.9 cm) with leveling legs fully adjusted 23 7/8” (60.7 cm) 4” 12” (30.5 cm) (10.2 cm) 2 11/16”...
  • Page 7 2. Insert the clear beverage line from the tower through the hole in the top of the unit. Mount the draft tower onto the refrigerator using the (4) furnished screws and (1) mounting gasket. 4. Fasten the CO 2 regulator to the...
  • Page 8 CO 2 REGULATOR 1. Low pressure gauge. (reads the amount of internal keg pressure) 2. Adjustment lock nut. 3. Regulator adjustment screw (after keg is tapped, screw clockwise until low pressure gauge indicates between 12 & 14 lbs.) 4. Shut-off valve. 5.

  • Page 9: Tapping Procedures

    TAPPING PROCEDURES There are two keg sizes: 1) the quarter barrel containing 7 3/4 gallons or approximately 3 1/2 cases of 12 ounce bottles or 2) the half barrel containing 15 1/2 gallons or approximately 7 cases. SANKEY TYPE KEG COUPLER (Taps all Coors , Miller...

  • Page 10: Final Preparation

    DRAIN HOSE AND CONTAINER Before using the beverage dispenser, make sure the drain hose and container are properly installed. 1. Attach the hose to the drain. 2. Attach the container to the hose. 3. Empty the container when it becomes full. 4.

  • Page 11: Setting The Control

    W W A A R R N N I I N N G G : : E E L L E E C C T T R R I I C C A A L L G G R R O O U U N N D D I I N N G G I I N N S S T T R R U U C C T T I I O O N N S S This appliance is equipped with a three prong grounding plug for your protection against shock hazard and should be plugged directly into a properly grounded three prong receptacle.
  • Page 12 HOW TO DRAW THE PERFECT GLASS OF BEER 1. Start with a clean beer glass that has been wetted in cold water. Place the glass at a angle, one inch below the faucet. Do not let the glass touch the faucet. . Open the faucet all the way.

  • Page 13: Common Draft Problems

    •Reduce door openings. •Close the door as soon as you can. •Keep the coils on bottom of the refrigerator clean. •Adjust the temperature control to a warmer setting when practical. •Keep unit away from the stove or other heat sources.

  • Page 14: Cleaning And Maintenance

    CLEANING AND MAINTENANCE Condenser The condenser tubing under the cabinet for forced air units does not require frequent cleaning. However, satisfactory cooling depends on adequate ventilation over the condenser. Be sure that nothing obstructs the air flow openings in the lower front of the cabinet. At least once or twice a year brush or vacuum lint and dirt from the condenser for efficient performance by unscrewing the grill on the bottom front of the cabinet.

  • Page 15: One Year Full Warranty

    For the name of your nearest authorized Viking Range Corporation service agency, call the dealer from whom the product was purchased or Viking Range Corporation. I I M M P P O O R R T T A A N N T T : : Retain proof of original purchase to establish warranty period.
  • Page 16 Viking Range Corporation 111 Front Street •Greenwood, Mississippi 38930 USA •(662) 455-1200 Specifications subject to change without notice F1755G (PS0806VR)

Table of Contents