Sony DVP-S330 Operating Instructions Manual page 49

Controlling the TV or the AV Receiver (Amplifier) with the
Supplied Remote [F]
If you adjust the remote signal, you can control your TV
with the supplied remote. Default setting is to control
Sony TVs with the & mark.
When you connect the player to a Sony AV receiver
(amplifier), you can also set the input of the receiver
(amplifier) to this player with the supplied remote.
TV/DVDeRECEIVER
switch 34—— — / (POWER)
Number buttons
Controlling TVs with the remote
1 Slide TV/DVDeRECEIVER switch to TV.
2 Hold down I/() (POWER), and enter your TV's
manufacturer's code (see the table) using the
number buttons. Then release I/() (POWER).
Code numbers of controllable TVs
If more than one code number is listed, try entering them
one at a time until you find the one that works with your
TV.
Notes
e If you enter a new code number, the code number previously
entered will be erased.
* When you replace the batteries of the remote commander, the
code number automatically resets to 01 (Sony). Reset the
appropriate code number.
Manufacturer Code
number
Sony (default) 01
Akai 04
AOC 04
Centurion 12
Coronado 03
Curis-Mathes 12
Daytron 12
Emerson 03,04,14
Fisher 11
General Electric 06,10
Gold Star 03,04,17
Hitachi 02,03
J.C.Penny 04,12
JVC 09
KMC 03
Magnavox 03,08,12
Marantz 04,13
MGA/Mitsubishi 04,12,13,17
NEC 04,12
Manufacturer Code
number
Panasonic 06,19
Philco 03,04
Philips 08
Pioneer 16
Portland 03
Quasar 06,18
Radio Shack 05,14
RCA 04,10 =
Sampo 12
Sanyo 11
Scott 12
Sears 07,10,11
Sharp 03,05,18
Sylvania 08,12
Teknika 03,08,14
Toshiba 07
Wards 03,04,12
Yorx 12
Zenith 15
49
syuawjsnip pue shuns