Cub Cadet 2000 Series Professional Shop Manual page 79

Drag links
Figure 6A.12
8. Disconnect the drag links from the forward most
holes in the sector gear using a 1/2" wrench and a 9/
16" wrench. See Figure 6A.12.
9. Install the steering gears by following the previous
steps in reverse order.
NOTE: Apply a small amount of releasable thread locking
compound such as Loctite® 242 (blue) to the sec-
tor gear bolt.
10. Inject grease into the grease fittings on the pivot bar
and the steering housing.
11. Perform a wheel alignment by following the steps
described in the steering alignment section of this
chapter.
12. Test drive the tractor in a safe area before returning
it to service.
Manual Steering
73