Table of Contents
Advertisement
[9] Removing the printed circuit boards.
e Remove the top cover (see step [1]).
TENN P.C.B.
1. Disconnect the connectors.
Exe P.c.B.
2. Remove the MAIN P.C.B. mounting screws (@ 2
1. Release the claws of the AC IN connector bracket.
pcs.).
3. Release the claws of the P.C.B. holders.
HEP.C.B.
1. Remove the keyboard assembly (see step [6]).
Mell P.c.B.
2. Remove the headphone jack mounting nuts @ 2
1. Release the claws of the P.C.B. holders.
pcs.).
3. Remove
the HP P.C.B.
mounting
screw
(@
1
EEGHP.c.B.
pcs.).
1. Disconnect the connectors.
2. Remove
the AS P.C.B. mounting screws
(@ 2
pcs.).
3. Release the claws of the P.C.B. holder.
Miter P.C.B.
1. Disconnect the connectors.
2. Remove the JACK P.C.B. mounting screws (@ 3
pcs.).
3. Remove
the jack panel mounting
screws
(@ 2
pes.).
P.C.B.
P.C.B.
P.C.B.
Mice P.c.B.
Remedy
eNo sound is produced if the MAIN VOLUME
is set to MIN.
Use the sliding control to set the volume to an appropriate level.
elf the MIDI LOCAL CONTROL is set to off, set it to on.
eThe metronome,
SEQUENCER
tempo, etc. are indicated on the
display. During normal performance, however, the display is off.
Phenomenon
No sound is produced when the key-
board is played.
Nothing is shown on the display.
m About the back-up memory
The selected sound and various functions, MIDI
while pressing the MODE SET button, press the
settings remain in the memory for about
1 week
INITIAL key on the keyboard. Or you can turn on
Advertisement
Table of Contents
