Sharpening Mower Blade - Snapper CLP21650RV Safety Instructions And Operator's Manual

MAINTENANCE INSTRUCTIONS
Remove the two blade mounting screws and nyloc lock
nuts. See Figure 18.
Remove blade and inspect for excessive wear and dam-
age. Refer to Figure 17 for blade wear limits.
Never use a blade that shows signs of
I TILT MOWER UP ON
I
I I_S BACK WHEELS! I
excessive wear or damagel Refer to
Figure 17 for blade wear limits,
\\
Install new blade onto blade hub. Refer to the Mainte-
nance Parts chart on Page 13 for the appropriate blade
part number, See Figure 19.
REMOVE MOUNTING
SCREWS AND NYLOC
LOCK NUTS
Install blade mounting screws and new nyloc lock nuts,
FIGURE 18
Torque blade mounting screws and nuts from 30 to 37
foot pounds.
Lower front of mower to ground.
Install grass catcher.
Place spark plug wire onto spark plug.
NYLOC LOCK NUT
BLADE HUB
SHARPENING MOWER BLADE
Move mower to a firm, level surface.
Stop engine.
Remove spark plug wire from spark plug and secure
wire away from plug.
Remove grass catcher.
Stand mower on rear wheels.
Remove the two blade mounting screws and nyloc lock
nuts. See Figure 18.
Remove blade and inspect for excessive wear and/or
damage, Refer to Figure 17 for blade wear limits.
BLADE_
FLANGE
BLADE
MOUNTING
SCREW
FIGURE 19
16