Vcr Plus+ Programming (Main Operation, Make Corrections) - Panasonic Omnivision VCRplus+ PV-4611 Operating Instructions Manual

[vf Before you begin, make sure...
O The clock is set.
O VCR Plus+ Set Up is complete (See pages 20, 21).
SPEED
CLEAH
6». 69. OS
Use normal Timer Recording steps if:
* the PlusCode for a program is not listed.
* you anticipate the program, such as a sporting
event, to run over the scheduled stop time.
See page 17 to:
* Cancel a timer recording in progress
* Replace program contents
* Review or Clear program contents once set
Important notes when using a DSS receiver
* When recording programs via a DSS receiver, the
DSS receiver must be left on.
* When recording programs via an antenna or cable,
the DSS receiver must be turned off.
VCR Plus+ and PlusCode are trademarks of
Gemstar Development Corporation.
The VCR Plus+ system is manufactured under
license from Gemstar Development Corporation.
VCR Plus+ Programming
VCR Plus+ Push VCR VOR Pluss.
|
i « Plus+ to display
ENTER VGA PLUSCODE
| the VCR Plus+ Llc
-.. -| Screen.
TO ENO PUSH VCR Ptus+
Push the Numbered m
Keys to enter the ENTER VCR PLUSCODE
PlusCode number. 123456
* Refer to your local TV listings. TO CORRECT PUSH CLEAR
TO ENTER PUSH VCR Plus+
To make corrections
Push the CLEAR button repeatedly to delete the PlusCode
number. Then, enter the correct number.
sh VCR
aie RN
8) Ò Plus+ to lock in
your program.
A Push 1, 2 or 3 Key to TE
select the program type. 1 ONE TIME
2 DAILY (MON-FRI)
3 WEEKLY
TO SELECT PUSH 1,2 OR3
TO END PUSH VCR Plus+
To change the recording speed: f pare sua strop cH
Press the SPEED button for SP, LP or SLP.| EXETER 15
To cancel program contents:
Press the CLEAR button.
TO CHANGE RECORD SPEED
PUSH SPEED KEY
TO CANCEL PUSH CLEAR
TO END PUSH VCR Plus«
* [f you use "A" connection on page 20, the channel shown in
the on-screen display in this step will always be the cable
box output channe! number.
| VCR Pues Push VCR Plus+ TURN VCA OFF
* If you're using a Cable Box, make
sure that it is tuned to the desired
channel and the power is left on for
timer recording.
* This display may differ
depending on your
cable box hook-up.
VCR Front Pane!
set the timer.
* Foralist of "Düblicalions that carry the e PlusCode numbers in your area, call 1 - 800- 258 - 4827.
YN 8 * You can obtain unlisted PlusCode numbers by calling 1 - 900 - 454 - 7587. Call costs approximately $.95 per minute.
[NOTES » VCR PlusCodes can not be used to program the VCA to record DSS channels.
* Avoid overlapping program times.
MY * An on-screen display will indicate if an invalid PlusCode number has been entered.
l * An on-screen sia will indicat wom a timer programs are TU