Akai EA-G90 Operator's Manual page 3

CONTROLS
2 126B/GREEN)
2608(0RANGE!
POWER Switch
Turns on and off the EA-G90. When the power is turned on, this
switch and the LEFT and RIGHT Channel Frequency Level con-
trols will light. Always press the upper section of this switch (near
the word POWER).
LEFT and RIGHT Channel Frequency Level Controls
The controls will light when the power is turned on.
When the EQUALIZER switch is turned ON , the levels of
these centre frequencies can be adjusted from +12 dB to —12dB
or +6 dB to —6 dB depending on the setting of the CONTROL
RANGE selector.
ATTENUATOR Switch
Turn ON ( «) this switch when the input level is targe. The input
level will be attenuated by 6 dB (1/2). Normally, this switched
should be turned OFF ( @).
CONTROL RANGE Selector with Indicator
+12dB (HL): To change the levels of the centre frequencies from
+12 dB to —12 dB. This selector and the Channel
Frequency Level controls will light green.
To change the levels of the centre frequencies from
+6 dB to —6 dB. This selector and the Channel
Frequency Level controls will light orange.
+6dB (mm):
. TAPE MONITOR Switch
Turn ON (-m) this switch when playing back a tape or when
monitoring during recording.
CHARACTER REVERSE Switch
Operates only when the EQUALIZER switch is turned ON.
Normally, this switch should be turned OFF ( 8). When this
switch is turned ON ( 2m), the characteristics that was equalizer
compensated by the Channel Frequency Level controls is reversed.
\f a control was set to +5 dB, it will become —5 dB.
Recording (REC) Switch
Turn ON the EQUALIZER switch and this switch when recording
equalizer compensated signals. Turn OFF (IL) this switch when
recording normal signals.
10.
11.
12,
EQUALIZER Switch
Turn ON this switch to adjust each Channel Frequency Lev-
el control. When set to DEFEAT position, the signals are
output without equalizer compensation. When the switch is set to
DEFEAT the Channel Frequency Level controls will go out.
INPUT Jacks
Connect to the TAPE REC jacks of an integrated amplifier with a
connection cord.
* In case the amplifier can be separated, connect to the PRE
OUT jacks,
OUTPUT Jacks
Connect to the TAPE PLAY jacks of an integrated amplifier.
* Incase the amplifier can be separated, connect to the MAIN IN
jacks,
TAPE Jacks
REC: Connect to the line in jacks of a tape deck.
PLAY: Connect to the line out jacks of a tape deck.
Power Cord
Connect to the AC outlet of an amplifier or a timer, orto a house-
hold AC outlet.